Rental Standards CheckVictoria Check your rentalThe check

Rental Standards Check Guides

Is ceiling insulation mandatory in a Victorian rental?

Updated 16/11/2026. Rules checked against Consumer Affairs Victoria and the regulations on 16/11/2026.

Yes, from 01/03/2027, at the start of a new lease, a renewal or a move to month to month, but only where the ceiling has no insulation at all. Ceilings that already have insulation of any R-value meet the standard, and new insulation must be at least R5.0 and fitted by a qualified installer.

The rule and its date

Schedule 4, clause 17 of the Residential Tenancies Regulations 2021 applies to a rental let under an agreement “entered into or created on or after 1 March 2027”. The insulation must:

  • have a minimum R-value of 5.0;
  • comply with AS/NZS 4859.1 and the fire tests named in the clause;
  • be a batt, not a foil or foil-faced product; and
  • be installed by a suitably qualified person in line with AS 3999, across the whole ceiling of the home.

A lease that was already month to month before 01/03/2027 is not caught until the next new lease or renewal, according to the energy.vic.gov.au guide for rental providers.

What does not need insulating

The clause leaves out four kinds of ceiling area:

  • areas that already have insulation, of any R-value;
  • external parts such as garages, outbuildings and alfresco areas;
  • internal ceilings, such as the ceiling of the lower floor of a double-storey home or the lower floors of an apartment block; and
  • areas where installing it is unreasonable or unsafe.

When it counts as unreasonable

The regulations list these grounds, without limiting others:

  • the cost is significantly higher than the average for an equivalent house or apartment, leaving out electrical work;
  • in an apartment building, the roof cavity is common property on the plan of subdivision;
  • owners corporation rules prohibit it, or another Act or local law makes the cost prohibitive;
  • it cannot be done without substantial building work or damage, for example skillion roofs, very low-pitched roofs, or roof spaces reachable only by removing the ceiling or roofing;
  • it would create health or safety risks greater than normal for insulation work; or
  • a heritage permit has been refused.

Consumer Affairs Victoria advises keeping proof when an exemption applies.

The electrical safety checklist comes first

Before insulation goes in, a licensed or registered electrician must complete a pre-insulation electrical safety checklist for the ceiling space. The insulation must then be installed within 30 days. Any work the electrician recommends must be done first, with a Certificate of Electrical Safety for it, and a copy of the checklist goes to the installer. If mains or solar cables in the ceiling are isolated for the job, a licensed or registered electrician must reconnect them afterwards.

Who can install it

Consumer Affairs Victoria says “Only a qualified installer can install ceiling insulation” and that you cannot self-install to meet this standard. The Minister for Energy and Resources may set the requirements for a qualified installer by notice in the Government Gazette, so ask the installer to confirm they meet it.

What it costs

What’s The Damage, a cost guide updated in November 2026, puts installed ceiling batts in Melbourne at $13 to $37 a square metre, about $21 typically, and $1,250 to $4,200 for a 3-bedroom home, GST included (What’s The Damage). For discounts, see the Victorian Energy Upgrades program.

Not sure whether your ceiling has any insulation? Look in the roof space with a torch before booking anything, then use the check to see the date it applies to your rental.

See what applies to your rental, with dates: use the check.

Questions

Is ceiling insulation mandatory in Victoria?

For rentals, yes, from 01/03/2027 at the start of a new lease, a renewal or a move to month to month, but only in ceilings that have no insulation. Existing insulation of any R-value meets it. Consumer Affairs Victoria

Do I have to top up old or thin insulation?

No. The standard excludes ceiling areas that already have insulation batts, blankets, rigid boards or loose fill, of any R-value. Regulations, Schedule 4 clause 17

Can a landlord install the insulation themselves?

No. Consumer Affairs Victoria says only a qualified installer can install it and you cannot self-install to meet the standard. Consumer Affairs Victoria

Ask for a quote

Your name, mobile and postcode are all we need. We pass your request to one Victorian rental compliance service, which books licensed tradespeople and will contact you to quote. You deal with them directly.

Add details (optional)

We are a referral service, not an electrician, plumber or gasfitter. See our privacy policy and how we make money.